A permeation liquid membrane system for determination of nickel in seawater

The use of a permeation liquid membrane system for the preconcentration and separation of nickel in natural and sea waters and subsequent determination by atomic absorption spectroscopy is presented. 2-Hydroxybenzaldehyde N-ethylthiosemi-carbazone (2-HBET) in toluene is used as the active component of the liquid membrane. A study strategy based on a simplex design has been followed. Several chemical and physical parameters were optimized. Maximum permeation coefficient was obtained at a feed solution pH of 9.4, 0.3 mol l⁻¹ of HNO₃ in the stripping solution and 1.66 mmol l⁻¹ of 2-HBTE in toluene as carrier. The precision of the method was 4.7% at 95% significance level and a detection limit of 0.012 μg l⁻¹ of nickel was achieved. The preconcentration procedure showed a linear response within the studied concentration range from 3 to 500 μg l⁻¹ of Ni in the feed solution. The method was validated with different spiked synthetic seawater and certified reference water samples: TMDA-62 and LGC 6016, without matrix interferences and showing good concordance with the certified values, being the relative errors −5.9% and −2.2%, respectively. Under optimal conditions, the average preconcentration yield for real seawater samples was 98 ± 5%, with a nickel preconcentration factor of 20.83 and metal concentrations ranging between 2.8 and 5.4 μg l⁻¹.     

Nb 掺杂LiFePO4/C 的一步固相合成及电化学性能

用固相法一步合成了Nb掺杂的LiFePO4/C复合材料, 研究了Nb掺杂量对材料电化学性能的影响. 结果表明, Nb掺杂后LiFePO4/C复合材料的电化学性能明显提高. 在0.5C、1C和2C充放电倍率下, 名义成分为Li0.96Nb0.008FePO4/C正极材料的比容量分别为161、148和132 mAh•g−1, 已达到实用化水平. 阻抗谱和循环伏安特性测试显示, Nb掺杂有效地降低了复合材料电极的阻抗和极化, 说明Nb掺杂的主要作用是提高了LiFePO4的电子电导率.     

Ionic discotic liquid crystals: synthesis and characterization of pyridinium bromides containing a triphenylene core

Five novel pyridinium salts tethered with hexaalkoxytriphenylene molecules were synthesized by the quaternization of pyridine with ω-bromo-substituted triphenylene derivatives. Their chemical structures were determined by ¹H NMR, ¹³C NMR, IR, UV spectroscopy and elemental analysis. The thermotropic liquid crystalline properties of these salts were investigated by polarizing optical microscopy and differential scanning calorimetry. These triphenylene-based pyridinium salts with bromide as counterion were found to be mesomorphic over a wide temperature range.     

Extraction of Nonylphenol and Nonylphenol Ethoxylates from River Sediments: Comparison of Different Extraction Techniques

Summary Five different extraction techniques (Soxhlet, automated Randall, accelerated solvent extraction, microwave-assisted solvent extraction and extraction with a surfactant solution) have been evaluated for the determination of nonylphenol (NP) and nonylphenol ethoxylates (NPEO) in river sediments. All the techniques were applied to the same three samples collected from northern Italian rivers. The analyses were performed with two RP columns, with different stationary reversed phases—a classical C₁₈ phase and a hexyl–phenyl phase. The recoveries and reproducibility of the different extraction techniques were comparable and all the methods gave reliable results. The variance of the results was dominated by the variance in sample homogeneity, sample preparation, and chromatographic analysis. A choice between the methods can be made on the basis of the cost and safety of each technique. Preliminary results obtained from use of a water-based extraction method with a surfactant solution (Tween-80), and its application to analysis of sediment and of worm tissue, are also presented.Presented at: Chemical Analysis and Risk Assessment of Emerging Contaminants, Barcelona, Spain, November 28–30, 2002     

Determination of didanosine in human serum by on-line solid-phase extraction coupled to high-performance liquid chromatography with electrospray ionization tandem mass spectrometric detection: application to a bioequivalence study

A method based on solid-phase extraction coupled to liquid chromatography with positive ion electrospray ionization and tandem mass spectrometric detection was developed for the determination of didanosine in human serum, using lamivudine as internal standard. The acquisition was performed in the multiple reaction monitoring mode, monitoring the transitions m/z 237 --> 136.7 for didanosine and m/z 230 --> 111.7 for lamivudine. The method was linear over the range studied (10-1500 ng ml(-1)), with r(2) > 0.98, and the run time was 5 min. The intra- and inter-assay precisions were < or =10% and the intra- and inter-assay accuracies were >95%. The absolute recoveries were 99.8% (10 ng ml(-1)), 98.4% (30 ng ml(-1)), 91.5% (700 ng ml(-1)) and 94.7% (1200 ng ml(-1)). The limits of detection and quantitation were 5 and 10 ng ml(-1), respectively. The method was applied to a bioequivalence study, in which 24 healthy adult volunteers (12 men) received single oral doses (200 mg) of reference and test didanosine formulations (buffered powder for oral solutions), in an open, two-way, randomized, crossover protocol. The 90% confidence interval of the individual ratios (test formulation/reference formulation) for C(max) (peak serum concentration) and AUC(0-inf) (area under the serum concentration versus time curve from time zero to infinity) were within the range 80-125%, which supports the conclusion that the two formulations are bioequivalent regarding the rate and extent of didanosine absorption.     

Determination of Biodiesel and Triacylglycerols in Diesel Fuel by LC

A high performance liquid chromatographic method was developed for quantifying blends of biodiesel (simple alkyl esters of fatty acids) in petrodiesel. The method uses a silica column with an isocratic mobile phase consisting of hexane and methyl t-butyl ether. Separated components were quantitated using either an evaporative light scattering detector (ELSD) or UV detector. Precision of injection and linearity of response of the ELSD and UV detectors over a range of biodiesel-petrodiesel blends [1–30 v/v %] were established by use of standards. The method also can be used for quantitating similar levels of oils or fats (triacylglycerols) in petrodiesel.     

Complexation and Separation of Amines,Amino Acids,and Peptides by Functionalized Calix[<Emphasis Type="Italic">n</Emphasis>]arenes

The ability of calix[n]arenes to form complexes, to act as extractants in liquid–liquid extraction, and run as carriers in transport through liquid membranes of different biological amine compounds (e.g., ammonium ion, amines, amino acids, and peptides) has been the central topics of many reports. These features recommend the calix[n]arenes as competitive candidates for studying the interactions involved in host–guest recognition as well as useful receptors in separation processes. Some specific aspects of their applications in binding and separation of various amine compounds by extraction, and in transport through liquid membranes have therefore been considered. The effect of the factors that might influence the separation of above compounds by extraction, and the transport through liquid membranes using the calix [n]arenes has been presented.This revised version was published online in July 2005 with a corrected issue number.     

反相高效液相三元流动相台阶梯度分离条件的快速优化方法

 根据溶质在柱内的迁移规律 ,建立了一种利用线性梯度实验快速获得溶质保留值方程系数 ,然后以串行响应函数为优化指标进行多台阶梯度分离条件优化的方法。与利用等度实验获得保留值方程的方法相比 ,该法可以大大缩短优化时间。通过该方法对芳香胺和衍生化氨基酸样品进行了分离 ,获得了满意的分离度 ,表明该方法的预测精度很好。     

指纹图谱法在参麦注射液质控中的应用

 中医药理论和实践要求综合评价中药的质量 ,指纹图谱法是对中药制剂进行综合宏观分析的可行手段之一 ,因此采用反相高效液相建立了参麦注射液的特征指纹图谱。条件 :Hypersil C18(4 6mmi d × 2 5 0mm ,5 μm)反相柱 ,流动相由水 (A)和乙腈 (B)组成 ,B的体积分数在 5 0min内由 5 %线性增长到 95 % ,流速为1 0mL/min ;紫外检测 ,波长为 2 0 2nm。 2 3个特征指纹峰与内标 (联苯 )的峰面积比作为指标 ,结合主成分分析 投影判别法比较了同一厂家不同批次产品和不同厂家同类产品的化学指纹差异。     

Polyterephthalamides with naphthoxy‐pendent groups

A series of new aromatic polyamides having pendent naphthoxy groups were synthesized by the triphenyl phosphite‐activated polycondensation of (2‐naphthoxy)terephthalic acid (NOTPA) with various aromatic diamines in a medium consisting of N‐methyl‐2‐pyrrolidone (NMP), pyridine, and calcium chloride. The diacid monomer NOTPA was prepared from the nitro displacement of dimethyl 2‐nitroterephthalate with the potassium naphthoxide of β‐naphthol, followed by base‐induced ester hydrolysis. All the resulting polymers were noncrystalline and readily soluble in aprotic polar solvents such as NMP and N,N‐dimethylacetamide. Almost all the polymers could be solution‐cast to tough, creasable amorphous films with good mechanical properties, the values of tensile strengths ranging from 90 to 124 MPa with initial moduli ranging from 1.72 to 2.51 GPa. Except for two examples, all the other polyamides displayed discernible glass transitions between 189 and 248 °C in the differential scanning calorimetric traces. These polyamides showed insignificant decomposition below 400 °C in nitrogen or air. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1781–1789, 2002